CD74AC574MG4 Overview
In the form of 20-SOIC (0.295, 7.50mm Width), it has been packaged. A package named Tubeincludes it. The output it is configured with uses Tri-State, Non-Inverted. Positive Edgeis the trigger it is configured with. Surface Mountis in the way of this electric part. The JK flip flop operates with an input voltage of 1.5V~5.5V volts. It is operating at -55°C~125°C TA. Logic flip flops of this type are classified as D-Type. In FPGA terms, D flip flop is a type of 74ACseries FPGA. In order for it to function properly, its output frequency should not exceed 125MHz. There are 1 elements in it. 20terminations have occurred. The 74AC574 family contains it. A voltage of 3.3V provides power to the D latch. A 10pFfarad input capacitance is provided by this T flip flop. A device of this type belongs to the family of AC. Electronic part Surface Mountis mounted in the way. A total of 20pins are provided on this board. A Positive Edgeclock edge trigger is used in this device. It is part of the FF/Latchesbase part number family. There are 8bits in its design. Vsup reaches its maximum value at 5.5V. The superior flexibility is achieved through the use of 8 circuits. The system runs on a power supply of 3.3/5V watts. This flip flop has a total of 2ports. In addition to its maximum design flexibility, the output current of the T flip flop is 24mA. It consumes 8μA current. Additionally, you may refer to the D latch's additional BROADSIDE VERSION OF 374.
CD74AC574MG4 Features
Tube package
74AC series
20 pins
8 Bits
3.3/5V power supplies
CD74AC574MG4 Applications
There are a lot of Texas Instruments CD74AC574MG4 Flip Flops applications.
- Parallel data storage
- Instrumentation
- Single Down Count-Control Line
- Count Modes
- CMOS Process
- Counters
- Test & Measurement
- Bus hold
- Communications
- Storage Registers
