SN74HCT374DWG4 Overview
The flip flop is packaged in 20-SOIC (0.295, 7.50mm Width). Package Tubeembeds it. This output is configured with Tri-State, Non-Inverted. It is configured with a trigger that uses a value of Positive Edge. This electronic part is mounted in the way of Surface Mount. The JK flip flop operates with an input voltage of 4.5V~5.5V volts. It is operating at a temperature of -40°C~85°C TA. D-Typeis the type of this D latch. JK flip flop is a part of the 74HCTseries of FPGAs. There should be no greater frequency than 40MHzon its output. In total, there are 1 elements. As a result, it consumes 8μA quiescent current and is not affected by external forces. There have been 20 terminations. You can search similar parts based on 74HCT374. A voltage of 5V provides power to the D latch. The input capacitance of this T flip flop is 3pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. This D flip flop belongs to the family of HCT. Electronic part Surface Mountis mounted in the way. A total of 20pins are provided on this board. This device has Positive Edgeas its clock edge trigger type. This device is part of the FF/Latchesbase part number family. There are 8bits in its design. The superior flexibility of this circuit is achieved by using 8 circuits. The system runs on a power supply of 5V watts. The flip flop contains 2ports. A high level of efficiency can be achieved by maintaining the supply voltage at 5V.
SN74HCT374DWG4 Features
Tube package
74HCT series
20 pins
8 Bits
5V power supplies
SN74HCT374DWG4 Applications
There are a lot of Texas Instruments SN74HCT374DWG4 Flip Flops applications.
- Set-reset capability
- Modulo – n – counter
- Supports Live Insertion
- Registers
- Storage registers
- Count Modes
- Latch
- Buffered Clock
- Circuit Design
- Patented noise
