CD74ACT74M96G4 Overview
The flip flop is packaged in SOIC. In total, there are 2 elements. Currently, there are 14 terminations. The D flip flop is powered by a voltage of 5V . Devices in the ACTfamily are electronic devices. A part of the electronic system is mounted in the way of Surface Mount. This board is designed with 14pins on it. This device has Positive Edgeas its clock edge trigger type. There is a base part number FF/Latchesfor the RS flip flops. An electronic part designed with 1bits is used in this application. As a result of its reliable performance, this T flip flop is suitable for TAPE AND REEL. It runs on 5Vvolts of power. If high efficiency is desired, the supply voltage should be kept at 5V. As of now, there are 1input lines. In terms of quiescent current, it consumes 4μA . -24mA is set as the high level output current. In the low level output current setting, 24mAis used. It is recommended that the operating temperature be below 125°C. Ideally, the operating temperature should be higher than -55°C. A minimum supply voltage of 4.5V is required for these RS flip flops to operate. In this case, it supports a maximum supply voltage of 5.5V. It is possible to achieve 85MHz frequencies. It uses a logic IC with a D FLIP-FLOP value. A total of 2 functions are available on the T flip flop. There are 14 pins on the D latch. This flip flop features a maximum design flexibility due to its output current of 24mA.
CD74ACT74M96G4 Features
14 pins
1 Bits
5V power supplies
2 Functions
14 pin count
CD74ACT74M96G4 Applications
There are a lot of Texas Instruments
CD74ACT74M96G4 Flip Flops applications.
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
- Memory
- Event Detectors
- Data Synchronizers
