CY74FCT374ATSOCT Overview

In the form of 20-SOIC (0.295, 7.50mm Width), it has been packaged. D flip flop is embedded in the Tape & Reel (TR) package. T flip flop uses Tri-State, Non-Invertedas the output. There is a trigger configured with Positive Edge. Surface Mountmounts this electrical part. A 4.75V~5.25Vsupply voltage is required for it to operate. In this case, the operating temperature is -40°C~85°C TA. This logic flip flop is classified as type D-Type. This type of FPGA is a part of the 74FCT series. This D flip flop should not have a frequency greater than 250MHz. D latch consists of 1 elements. As a result, it consumes 200μA quiescent current and is not affected by external forces. There have been 20 terminations. The 74FCT374 family contains it. It is powered by a voltage of 5V . Its input capacitance is 5pFfarads. Devices in the FCTfamily are electronic devices. There is an electronic part that is mounted in the way of Surface Mount. The electronic flip flop is designed with pins 20. In this device, the clock edge trigger type is Positive Edge. This RS flip flops is a part number FF/Latches. The design is based on 8bits. 8 circuits are used to achieve its superior flexibility. Considering the reliability of this T flip flop, it is well suited for TR. In order for the device to operate, it requires 5V power supplies. The flip flop has 2embedded ports. High efficiency requires the supply voltage to be maintained at 5V. With a current output of 64mA , it offers maximum design flexibility. It is designed with 3 output lines.

CY74FCT374ATSOCT Features

Tape & Reel (TR) package
74FCT series
20 pins
8 Bits
5V power supplies

CY74FCT374ATSOCT Applications

There are a lot of Texas Instruments CY74FCT374ATSOCT Flip Flops applications.

• Reduced system switching noise
• Single Up Count-Control Line
• Control circuits
• Registers
• Functionally equivalent to the MC10/100EL29
• Load Control
• Digital electronics systems
• Memory
• ATE
• Computing