SN74ALS874BNSRE4 Overview
In the form of 24-SOIC (0.209, 5.30mm Width), it has been packaged. It is included in the package Tape & Reel (TR). Tri-State, Non-Invertedis the output configured for it. It is configured with a trigger that uses a value of Positive Edge. Surface Mountmounts this electrical part. The supply voltage is set to 4.5V~5.5V. Currently, the operating temperature is 0°C~70°C TA. This D latch has the type D-Type. JK flip flop belongs to the 74ALSseries of FPGAs. It should not exceed 30MHzin terms of its output frequency. A total of 2elements are contained within it. There is 21mA quiescent consumption. There are 24 terminations,It is a member of the 74ALS874 family. An input voltage of 5Vpowers the D latch. This D flip flop belongs to the family of ALS. There is an electronic part that is mounted in the way of Surface Mount. With its 24pins, it is designed to work with most electronic flip flops. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. This RS flip flops is a part number FF/Latches. It reaches 5.5Vwhen the maximum supply voltage (Vsup) is applied. As a result of its reliability, this D flip flop is ideally suited for TAPE AND REEL. The D latch runs on a voltage of 5V volts. There are 2 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. In addition to its maximum design flexibility, the output current of the T flip flop is 24mA. There are 1 output Lines, which generate the binary equivalent of the input line whose value is equal to “1” and are available to encode either a decimal or hexadecimal input pattern to typically a binary or “B. C. D” (binary coded decimal) output code.
SN74ALS874BNSRE4 Features
Tape & Reel (TR) package
74ALS series
24 pins
5V power supplies
SN74ALS874BNSRE4 Applications
There are a lot of Texas Instruments SN74ALS874BNSRE4 Flip Flops applications.
- Load Control
- Shift Registers
- Test & Measurement
- EMI reduction circuitry
- Common Clocks
- Consumer
- Count Modes
- Memory
- Guaranteed simultaneous switching noise level
- Computing
