Due to its 8-XFBGA, DSBGA packaging, the electronic part is convenient for international shipping. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). Surface Mount is where this multiplexer is located. 2:1 is the ratio of multiplexer to demultiplexer circuits. The operating temperature is extended to around -40°C~85°C TA. Total terminations are 8. This electronic part offers high-quality output due to its 2 channels. If the voltage supply is 1.1V volts, the electrical component should be turned on and run. A total of 8 pins are injected into the electrical part body. Based on SPDT switching circuits, these analog multiplexers work. The multiplexer consists of 1 circuits. Look for analog switch ic variants by searching with 74AUC2G53. Analog switches have 15Ohm internal resistance. You can find the functions of the 8 pins in the datasheets. It is a typical Multiplexer or Switches analog multiplexer. An abnormal situation would be for the switch device to be supplied with a voltage greater than 2.7V. A analog switch ic that has a cost-effective Single supply type. The lowest voltage the electronic part should receive is 800mV. The switch device would be able to operate with 10μA current. This analogue multiplexer requires a voltage of 0.8V~2.7V when it drains from a single voltage supply. The switch multiplexer may be damaged if it is exposed to voltage greater than 10μA. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer. The electrical component supports 2 inputs. There are various bandwidths available for data transfer.