The electrical component comes in 20-TSSOP (0.173, 4.40mm Width) packaging, which makes it convenient to ship overseas. In order to provide high reliability, an advanced packaging method Tube is used. The multiplexer is located in Surface Mount. Multiplexer and demultiplexer circuits have a number 2:1. The operating temperature is extended to around -40°C~125°C TA. 20 terminations have been made so far. A 1 channel electronic part produces high-quality output. It is safe to turn on and run the electronic component with a 15V voltage supply. It is injected into the electrical part body with 20 pins. Multiplexers built on a SPDT switching circuit are built. Try searching for ADG5234 variants of the analog switch ic. In this multiplexer, the internal resistance is 200Ohm. The functions of 20 pins can be found in the datasheets. Multiplexer or Switches is a typical switch device. In normalcircumstances, users should not exceed 40V volts for the multiplexer. A cost-effective Dual, Single supply type analogue multiplexer. The lowest voltage fed to the electronic component should be 9V. Putting voltage greater than 55μA on the multiplexer may cause damage. Despite this switch's dual supply capability, its voltage should not exceed 22V. A dual power supply should have at least 9V voltage attached. There are 4 inputs to be operated. 205MHz-bandwidths can be used to transfer data between multiplexers. Check out the electrical component's additional features, such as the following: VIDEO APPLICATION. The analog switch ics has 8 outputs.