SN74LV273APWR Overview

It is embeded in 20-TSSOP (0.173, 4.40mm Width) case. D flip flop is embedded in the Tape & Reel (TR) package. There is a Non-Invertedoutput configured with it. In the configuration of the trigger, Positive Edgeis used. It is mounted in the way of Surface Mount. A 2V~5.5Vsupply voltage is required for it to operate. It is at -40°C~125°C TAdegrees Celsius that the system is operating. There is D-Type type of electronic flip flop associated with this device. JK flip flop is a part of the 74LVseries of FPGAs. A frequency of 160MHzshould not be exceeded by its output. A total of 1elements are contained within it. As a result, it consumes 20μA quiescent current and is not affected by external forces. In 20terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. It is a member of the 74LV273 family. Power is supplied from a voltage of 2.5V volts. JK flip flop input capacitance is 2pF farads. It belongs to the family of electronic devices known as LV/LV-A/LVX/H. Electronic part Surface Mountis mounted in the way. This board is designed with 20pins on it. It has a clock edge trigger type of Positive Edge. There is a base part number FF/Latchesfor the RS flip flops. An electronic part designed with 8bits is used in this application. Vsup reaches its maximum value at 5.5V. For normal operation, the supply voltage (Vsup) should be kept above 2V. 8 circuits are used to achieve its superior flexibility. In view of its reliability, this D flip flop is a good fit for TR. A total of 3.3V power supplies are needed to run it. This T flip flop features a maximum design flexibility due to its output current of 25mA. It is reported that there are 2 input lines.

SN74LV273APWR Features

Tape & Reel (TR) package
74LV series
20 pins
8 Bits
3.3V power supplies

SN74LV273APWR Applications

There are a lot of Texas Instruments SN74LV273APWR Flip Flops applications.

• ESD protection
• Set-reset capability
• Communications
• Clock pulse
• Safety Clamp
• High Performance Logic for test systems
• Divide a clock signal by 2 or 4
• Balanced 24 mA output drivers
• Single Down Count-Control Line
• Guaranteed simultaneous switching noise level